Circle > Circumcircle (Temporary Objects Menu)

This command is used to create a Temporary Object as a circle. The circle is calculated by entering three points through which it should run. This is the same as calculating the circle surrounding a triangle.

If a circle is to be drawn while working in isometric or dimetric views, this must be done with the command Ellipse > Vector - Vector because the result on the page is not circular but elliptical.

The first point through which the circle should run can be entered by clicking the mouse anywhere within the drawing.

The second point through which the circle should run can be entered by clicking the mouse anywhere within the drawing.

The third point through which the circle should run can be entered by clicking the mouse anywhere within the drawing.