Rotate Set of Points (Modify Menu)

This command can be used to rotate a set of definition points at the same time. The center of rotation and the angle are both specified by point entry.

Choose the points that shall be rotated. Click on points to choose them.

Definition points in Construction Aid endless lines and beams can only be chosen if both check boxes "Point markings" and "Also for Construction Aid" in the "Additional Information" area of the "Screen Settings" dialog are active. Otherwise, they will be ignored.

The rotation point, i.e. the center of rotation, can be entered by clicking the mouse anywhere in the drawing.

The rotations's start angle can be entered by clicking the mouse anywhere in the drawing. The position of this point relative to the reference point determines the start angle.

The rotations's end angle can be entered by clicking the mouse anywhere in the drawing. The position of this point relative to the reference point determines the end angle.