Construction Aid Circle > Circumcircle (Construct Menu)

This command draws a Construction Aid circle. The Construction Aid circle is determined by three points through which it should run. This is the same as calculating a triangle's circumcircle.

If a Construction Aid circle is to be drawn while working in isometric or dimetric views, this must be done with the command Construction Aid Ellipse > Vector - Vector because the result on the page is not circular but elliptical.

The first point through which the Construction Aid circle should run can be entered with the mouse by clicking anywhere in the drawing.

The second point through which the Construction Aid circle should run can be entered with the mouse by clicking anywhere in the drawing.

The third point through which the Construction Aid circle should run can be entered with the mouse by clicking anywhere in the drawing.