Export to > Create File Export Procedure, Rectangle (File Menu)

Using this command, you can create a file export procedure based on a rectangular section of the drawing.

The first corner point of the section can be entered by clicking the mouse at any point within the drawing.

The second corner point of the section can be entered by clicking the mouse at any point within the drawing.

After entering the rectangle, the "File Selection" dialog appears in which the file name and file type to be used can be chosen.

After choosing the file name, the "Edit Procedure" dialog appears in which the name and parameters of the procedure are entered.

The data is created as if for printing, i.e. the output pen and layer properties are used.