Circle > On Circle (Draw Menu)

This command draws a circle based on another circle or a circle part.

This command is especially useful if a Construction Aid circle is to be transferred into the drawing. It can also be used to draw a circle over an existing circle part.

If a circle is to be drawn while working in isometric or dimetric views, this must be done with the command Ellipse > Vector - Vector because the result on the page is not circular but elliptical.

Any circle which exists independently or as part of another object can be identified as the reference object. This can also be the arc of a circle segment or a circle arc within a surface.

The circle is assigned to the current layer. In addition, it contains a reference to the current pen.