Re-Enter Polygon (Procedure Menu)

This command allows to re-enter the polygonal section of an already defined Procedure.

The start point of the polygon can be entered by clicking the mouse anywhere in the drawing.

After entering the start point, more points can be entered. The polygon begins at the start point, runs through all the subsequently-entered points and ends at the start point. These points can be entered by clicking the mouse anywhere in the drawing.

Once all desired points have been entered (at least 3), press the right mouse button to finish the command. If the Workflow Manager is active and appears, choose Finish Command in it.

The polygon can have up to 100 segments. If this limit is reached during entry, then further point entry is not allowed.